Siegenia KFV A-Opener 2.2, Assembly Instructions Manual

Electro-mechanical systems

Assembly instructions

A-opener 2.2

09.2019

4/20

H39.ELEKS011EN-00

1 

Introduction

Please read these instructions carefully before you 

begin the assembly work. Follow the notes in Chapter 2 

"Safety", in order to prevent personal injury or func

-

tional disorders.
These instructions are an integral part of the A-opener 

2.2 and must be accessible to the specialist personnel 

at all times.

1.1 

Producer and service

KFV Karl Fliether GmbH & Co. KG 

A company of the SIEGENIA GROUP

Siemensstraße 10 

42551 Velbert
Tel.: +49 2051 278-0 

Fax: +49 2051 278-167 

E-mail: info@kfv.de
Please contact your contractual partner in case of com

-

plaints or service requirement.

1.2 

Target group of this documentation

This documentation is intended for use by specialists 

only. All work described in this document is to be per

-

formed only by experienced professionals with train

-

ing and practice in the assembly, commissioning and 

maintenance of electromechanical components and 

multi-point locks. 
All work on a 230 V AC mains power supply may only 

be performed by a qualified electrician.

1.3 

Intended use

• 

In combination with automatic multi-point locking, 

the A-opener 2.2 enables motorised unlocking and 

is suitable for installation in timber, aluminium, steel 

and PVC entrance doors.

• 

The A-opener 2.2 may only be used

– 

with cylinder locks with a rigid catch in which 

the catch is locked in a key withdrawal position 

inside the range of - 30° to + 30°

– 

with cylinder locks with a non-restrictive catch in 

which the catch can always be freely turned

– 

in vertical installation

– 

in a technically sound condition

– 

in conjunction with KFV products and accessories

1.4 

Improper use

• 

The A-opener 2.2 must not be used in combination 

with an automatic multi-point locking system

– 

for escape doors in accordance with EN 179 or 

EN 1125

–  in doors for wet rooms or rooms in which the air 

contains aggressive or corrosive components

• 

The A-opener 2.2 and the automatic multi-point 

lock must not be interfered with or modified.

1.5 

Maintenance and service notes

Never use cleaning agents that are aggressive or con

-

tain solvents. This could damage the surfaces of the 

components.

1.6 

Installation conditions and requirements

Local building laws and regulations must be observed 

before and during installation. 

1.7 

Dimensions

All measurements are given in mm.

1.8 

Symbols used

The following icons are used in this document:

General warning symbol

Useful information or advice

1.9 

Other types of indicators

Below is a list of symbols used in these instructions and 

their meanings:

• 

Items of text following this marker are found in lists.

– 

Items of text following this marker are found in 

subordinate lists.

f

Items of text with this marking in front of them are 

instructions that must be followed in the specified 

order.

Cross reference

()  A cross reference in the flow text is enclosed by 

brackets.