IV405E Rev.000 SIEL S.p.A.
Data di emissione: 2018-06-22
Pag. 31 di 50 + FR
4.4 Parameters setting
The setting function is controlled by 3 buttons (
P
, OFF, ON) :
P
---goes into the setting page and
value adjustment; OFF---for exit setting;
P
---for choosing different pages.
After the UPS turn ON, press buttons “
P
”
& “
OFF
” for 2
seconds and then goes into the setting
interface page.
4.4.1 Mode setting
Mode setting (Note: Inside the broken-line is the flashing part.)
After entering the setting menu, its mode setting defaulted, and the mode setting line flashing as
in above picture.
U
se button “
P
” to choose different mode. There are 3 different modes for setting:
ECO, PAL, NOR.
ཱ
Press
“
ON
” to exit the mode setting
and save the mode setting value, and goes
to output voltage setting.
ི
Press
“
OFF
” to exit the mode setting, and goes to p
arallel redundancy
quantity setting.
4.4.2 Output voltage setting
Output voltage setting (Note: Inside the broken-line is the flashing part.)
In
the mode setting press “O
N
” or
in
frequency setting press “Off”, it goes to the output voltage
setting. The output voltage line flashes as in above picture.
U
se button “
P
” to choose the different
output voltage. There are 3 different voltages---220, 230, 240.
ཱ
Press
“
ON
”
to exit the output
voltage setting and save the output voltage setting value, and goes to frequency setting.
ི
Press
“
OFF
”
to exit the output voltage setting, and goes to mode setting.
