ENGLISH
Siemens AG
610.40 700.21
13
Encoder system with
DRIVE-CLiQ Interface
- I22DQ = incremental encoder 22 bit
- AM22DQ = absolute value encoder 22 bit Singleturn
+ 12 bit Multiturn
- AM20DQ = absolute value encoder 20 bit Singleturn
+ 12 bit Multiturn
- AM16DQ = absolute value encoder 16 bit Singleturn
+ 12 bit Multiturn
- AM15DQ = absolute value encoder 15 bit Singleturn
+ 12 bit Multiturn
- Resolver 15 bit
- Resolver 14 bit
Shaft end
cylindrical with keyway and feather key;
(DIN 748-3; IEC 60072-1)
Tolerance range k6 (balancing with half feather key)
You will find more technical details, e.g. motor dimensions, in the catalogs NC 60, NC 61,
D 21.1 or Configuration Manual.
4
Transport, Installation and Assembly
4.1
Transport, Storage
Observe the transport regulations applying in the country/countries concerned.
Use suitable load suspension devices for transport and assembly.
Use lifting eyes for transporting the motors where these are provided by the manufacturer.
Lifting tackle as per 98/37/EU Directive for Machines, Appendix I.
The motor weight is indicated on the rating plate.
Fig. 2 Lift and transport with suspension bands
WARNING
Danger during lifting and transporting procedures!
Improper handling, unsuitable or defective devices, tools etc. can
cause injuries and/or property damage.
Lifting devices, ground conveyors and lifting tackle must correspond
to the valid regulations.
