ENGLISH
10
610.40068.01
Siemens AG
4
Installation, assembly
4.1
Transport, storage
Use suitable load suspension devices for transport and assembly. Use lifting eyes for
transporting the motors where these are provided by the manufacturer.
Lifting tackles are per 98/37/EU Directive for machines. Appendix I.
The motors weigh up to 50 kg. For exact details, please refer to the catalog or dimensional
sheet.
Observe the transport regulations applying in the country/countries concerned.
Store in a try-dust and low-vibration place (veff < 0,2 mms
-1
) .
4.2
Installation
Fig. 2
Types of construction
-
Take note of and observe the information on the rating plate and warning and informative
notice on the motor.
-
Observe the permitted transverse and axial forces (see enclosure 1).
-
Check for compliance with the conditions (e.g. temperature, site altitude) at the assembly
site (see section 3.2).
-
Remove all anti-corrosion agents from the shaft end (use commercially available
solvent).
WARNING
Danger during lifting and transporting procedures!
Improper handling, unsuitable or defective devices, tools etc. can
cause injuries and / or property damage.
Lifting devices, ground conveyors and lifting tackle must correspond
to the valid regulations.
1FS6074
1FS6096
(IM V1, IM V3)
1FS6115
1FS6134
(IM V15, IM V36)
B5
B35
