Maintenance
6.1 Maintenance
A5E01083943A AB
Siemens AG Operating Instructions 2.02 1FW4
73
CAUTION
Hazard due to chemical cleaning agents
If you use chemical cleaning agents, observe the instructions and any warnings given in the
relevant safety data sheet. Chemical agents must be compatible with the motor's
components/parts, especially when they contain plastics.
[ID 1150.00]
See also
Danger and warning notices (Page 7)
6.1.3
Regreasing intervals for rolling-contact bearings, grease type
Grease types
The regreasing intervals, the amount of grease and the type of grease used for the initial
lubrication are specified on the motor's lubrication instruction plate. If the specified number of
operating hours is not reached within three years, the bearings must be regreased ahead of
schedule during the main inspection. For the standard range of applications, a grease for
temperatures down to -20°C is normally used for the initial greasing of the bearings. The
amount of grease for the initial lubrication is 25% to 35% of the free bearing volume.
You must not run the motor for a long period of time at speeds less than 10 rpm, because no
lubricating film will form.
The following high-quality greases for rolling-contact bearings are suitable and tested for
temperatures down to -20°C.
Table 6-1
Suitable greases for rolling-contact bearings (down to -20°C)
K1K grease
ESSO/Beacon EP 1
FUCHS/Renolit MP
CAUTION
Mixing greases
Never mix greases that have different thickening agents and base oils.
Regreasing
1.
Clean the grease nipple.
2.
Apply a portion of an appropriate type of grease in the amount specified on the lubricant
plate. The shaft must rotate so that the new grease can be distributed throughout the
Summary of Contents for 1FW4
