DataNET Copper Connections
Before You Begin
This section provides instructions for connecting the Maxum to a
DataNET network. All DataNET connections are made to the ANCB. The
DataNET connections can be either copper or fiber.
The ingress wiring method (conduit or cable glands) and which cable
type you use is dependent upon the site requirements. Review the Site
Wiring Requirements page 8 to ensure that you are using the correct
cable and wiring method.
Refer to ANCB Description page 46.
J12
J4
10B ase2
10B aseT
J 10 P ort 1
For ANCB: Ju mpers on
Botto m 3 Po sition s O n ly
J11 Port 2
For ANCB Ju mp ers on
Botto m 3 po sition s O n ly
Config Port
RS232
57.6 KB
J2 Ju m p er Co nn ection s
•
•
150 Oh m
•
•
120 Oh m Port 2 (DN)
•
•
100 Oh m
•
•
150 Oh m
•
•
120 Oh m Port 1(DN)
•
•
100 Oh m
Default S etting on 150 o hm
Position s
Board
RESET
O peration LED S
J5
Default on Pins 1 &2
Figure 1-1: ANCB Board
Jumper Settings
NAU Installations
For rack mount units the SYSCON connections are visible at the rear of
the NAU. If you have a wall mounted unit you must first remove the front
or side safety box access covers to see the SYSCON connections.
Instructions
Step Action
1.
Turn off AC Power (Mains) to the unit.
2.
Route incoming the DataNET copper cables to the ANCB
in accordance with national or local electrical codes and
regulations.
14
•
Installation
2000592-001
