SIEMENS 5930/5935 Business Gateway
User’s Guide
Chapter 3 Easy Setup
Select Protocol
SIEMENS
22
Point-to-Point Protocol over ATM
If you selected
Point-to-Point Protocol over ATM
from the Wan Interface page, the Point-to-Point Protocol
page is displayed when you click
Next
.
To configure Point-to-Point Protocol:
1. Enter
PPP
User Name
and
Password
to use for authentication when establishing a WAN connection using
PPP protocol.
2. Select one or more of the following PPP Networking options:
•
Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select
Only bridge PPPoE traffic
.
If selected, only PPPoE traffic is bridged; all other traffic is
stopped.
3.
IP Routing Enabled:
Route all IP traffic to remote hosts.
4. If you enabled IP routing, optionally select one or more of the following:
•
NAT Enabled:
Network Address Translation (NAT) allows multiple workstations on your LAN to share a single, public
IP address. All outgoing traffic appears to originate from the router’s IP address.
•
Block Net BIOS Traffic:
NetBIOS is a PC networking protocol that can keep network connections open inadvertently. To avoid
excess connection charges, such traffic should be blocked on any metered network service.
5. Click
Next
. This displays the
Dynamic Host Configuration Protocol
page.
