Operation
6.4 Communication in batch mode (SIMATIC MV325)
SIMATIC MV320 / SIMATIC MV325
Operating Instructions, 08/2015, C79000-G8976-C352-03
33
6.4
Communication in batch mode (SIMATIC MV325)
In batch mode, you can collect data with the reader and buffer it in the reader. Depending on
the selected batch mode, the data is not transferred to the host device until you put the
reader back in the charging station or scan the configuration code for data transmission.
You can distinguish between the following communication modes for communication in batch
mode:
●
Via Bluetooth
●
Via USB port
Depending on the required communication mode, you must move the switch on the bottom
of the charging station
③
to the corresponding position.
①
Data is transmitted over Bluetooth (direction of the arrow)
②
Data is transmitted over USB port
Transmission of saved data via Bluetooth
Use the following procedure to enable data transmission in batch mode via Bluetooth:
1.
Move the switch
③
for the communication mode on the bottom of charging station to the
position
①
(direction of the arrow).
2.
Scan the configuration barcode of the batch mode:
–
Batch Mode Enable - Log Only
1)
3.
Scan the "QuickConnect" code on the front of the associated charging station or the
associated Bluetooth modem.
Once you have enabled the communication mode, you can start collecting data.
To transfer the data to the host device, you must scan the configuration code "Batch Mode
Transfer All Data in Memory".