Output Capacity Kit
15900-407
4.
Align the selected gasket with the matching air passages and mounting holes in the new spool block.
5.
Insert the two 8-32 screws supplied in the kit through the block and gasket. (The high capacity block requires
the longer screws supplied in the kit.)
6.
Install the block and gasket in the enclosure. Align the spool block and gasket with the air passages and
mounting holes in the enclosure. Tighten the hardware to 20 lb in. (2.3 N m).
7.
Lift the beam assembly slightly and insert one end of the spool clip into the bronze bushing in the under side of
the beam assembly. Insert the other end of the spool clip into the countersunk end of the spool at the top of the
spool block. The longest section of the clip should be positioned inside the V-shaped slot in the front of the
beam. See Figure 3.
Do not permanently deform the clip from the original shape.
Note
If the spool clip is deformed, refer to the drawing below and carefully re-form the clip as
shown.
M
G
0052
4a
1.91" +/- .020"
8.
Model 760E only: Install the I/P Transducer. Refer to SD760 as needed.
9.
Refer to the Calibration section of SD760 and test the Positioner to ensure that the spool valve is operating
freely and that there are no air leaks. Check Positioner calibration and calibrate if necessary.
10.
Install the enclosure cover, tighten screws to 20 in lbs (2.3 Nm) and install the Positioner.
CUSTOMER/PRODUCT SUPPORT
For the location of your local Siemens representative, visit the Siemens Process Instrumentation product support
page at
http://www2.sea.siemens.com/Products/Process-Instrumentation/Support/Customer-Support.htm
.
For technical support refer to the following table and click the appropriate link.
Technical Support
Online Support Request
http://www.siemens.com/automation/support-request
Telephone
1 800 333 7421
Hours of Operation
8 a.m. to 4:45 p.m. eastern time, Monday through Friday (except holidays)
Technical
Publications
in PDF
http://www2.sea.siemens.com/Products/Process-Instrumentation/Support/PI-User-
Manuals.htm
then click the product line (e.g. Control Solutions)
Public Internet Site
http://www2.sea.siemens.com/Products/Process-Instrumentation
Repair Service
1 800 365 8766 extension 3187 (for warranty and non-warranty service)
ValvePAC is a trademark of Siemens Energy & Automation, Inc.
Viton® is a registered trademark of DuPont Performance Elastomers.
Nomex is a trademark of
E. I. du Pont de Nemours and Company.
All product designations may be trademarks or product
names of Siemens Energy & Automation, Inc. or other supplier companies whose use by third parties for their own purposes
could violate the rights of the owners.
Siemens Energy & Automation, Inc. assumes no liability for errors or omissions in this document or for the application and use
of information in this document. The information herein is subject to change without notice.
Procedures in this document have been reviewed for compliance with applicable approval agency requirements and are
considered sound practice. Neither Siemens Energy & Automation, Inc. nor these agencies are responsible for repairs made by
the user.
4
January
2009
