Synchronizing up to 12 SIPROTEC 4 or SIPROTEC 5 Devices
This use case is an extension of the basic configuration from chapter
3.2 Synchronizing up to 6 SIPROTEC 4 or
. The Sync-Transceiver is now operating in channel pairing mode and provides the time
protocol of the GPS receiver to 2 semiconductor switch outputs at the same time. Using the T adaptor cable
7XV5104-3AA00, you can now connect 2 lines from cascaded Y bus cables 7XV5104-0AAxx, each having a
maximum length of 10 m, to the Sync-Transceiver. In this configuration, the number of SIPROTEC 4 or
SIPROTEC 5 devices that can be connected doubles to 2 × 6 = 12.
Table 3-2
DIP Switch Positions in the Sync Transceiver
Switch
Position
S1/1
Application-specific (light idle state mode as per the system configuration at the optical-fiber
input R1)
S1/2
Open
S1/3
Closed (channel pairing mode)
S1/4
Open
[dw_max-12-SIP4-device_with-R1-synch, 1, en_US]
Figure 3-2
Synchronizing a Maximum of 12 SIPROTEC 4 Devices Using R1
3.3
Application Examples
3.3 Synchronizing up to 12 SIPROTEC 4 or SIPROTEC 5 Devices
26
Accessories, Sync Transceiver, Optical/Electrical Converter for Time Synchronization, Manual
C53000-G9050-C168-1, Edition 09.2019
