en
Installation instructions
40
Recommended settings for microwave cooking
Food
Accessory/cook-
ware
Shelf pos-
ition
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Egg and milk mixture
Uncovered cook-
ware
1
-
1.
360
2.
180
1.
20
2.
20-25
Sponge
Uncovered cook-
ware
1
-
600
7-9
Meat loaf
Uncovered cook-
ware
1
-
600
22-27
Recommended settings for cooking in combination with the microwave mode
Food
Accessory/cook-
ware
Shelf pos-
ition
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Potato gratin
Uncovered cook-
ware
1
150-170
360
25-30
Cakes
Uncovered cook-
ware
1
190-210
180
12-18
Chicken, halved
Uncovered cook-
ware
1
180-200
360
25-35
29 Installation instructions
Observe this information when installing the appliance.
29.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡
The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35 mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡
Ventilation slots and intake openings must
not be covered.
¡
The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡
Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡
Proceed in accordance with the installation
sheets for installing accessories.
¡
Fitted units must be heat-resistant up to
95 °C, and adjacent unit fronts up to
70 °C.
¡
Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡
The mains socket for the appliance must
either be located in the hatched area or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket .