8
Starting Wellness Program 1
■
Press on the Wellness Program
button 1
. The display lights up
in color and the stored shower temperature appears in °C and P1.
■
Now open the water tap within 2 minutes and Wellness
Program 1 starts. Warm water will run from the shower for 2 min-
utes according to the temperature setting and then cold water will
flow out for 30 seconds.
Tip:
The best effect is obtained if you run Wellness Program 1 twice
in succession.
Starting Wellness Program 2
■
Press on the Wellness Programm
button 2
. The display lights up
in color and the stored shower temperature appears in °C and P2.
■
Now open the water tap within 2 minutes and Wellness
Program 2 starts. At first, warm water will run for 1 minute (water
temperature depends on your setting) and then 30 °C warm water
will be dispensed for 30 seconds.
Tip:
Wellness Program 2 should be used a number of times in suc-
cession and can be repeated as often as desired.
Ending Wellness Program 1 or 2
Both programs will repeat until either the
button 1
or
2
is pressed
(depending on the program selected) or the water faucet is shut off
for more than 2 minutes or the temperature setting is changed. The
temperature which was set before the program was started will be
re-activated.
The programs can also be activated while the water is running.
Changing the temperature in a Wellness Program
The preset temperature for the warm phase is 39 °C. This can be
altered within the range 30 °C to 42 °C.
■
Use the rotary knob to set the desired temperature within the
range 30 °C and 42 °C.
■
Store this value by holding down
button 1
for three seconds.
The selected temperature is now stored in Wellness Program 1.
The temperature in Wellness Program 2 can also be altered in ex-
actly the same way. Store this by holding down
button 2
for three
seconds.
