13/140
Siemens
RXB (KNX) Applications library
CLC and RAD description of functions for CC-02 CM110384en_03
Building Technologies
Definitions / Tools
28 Feb 2009
2.5
Parameterization using the HandyTool
The HandyTool function is included in the QAX34.3 room unit allowing you to
parameterize RXB room controllers (as of version 2.36).
The following settings are possible in the room controllers:
•
Parameters.
•
Physical address.
•
Zones.
Group addresses (bindings) cannot be assigned.
This must be carried out in ETS.
In addition to its room unit functionality, this device also allows for parameterizing room
controllers.
If the room controller was preprogrammed (via ETS3, ACS or HandyTool).
– Physical address.
– Zones (when in LTE mode).
– Setpoints.
– Master/slave settings.
– All parameters.
The parameter numbers and their functions are described in the sections below.
HandyTool
QAX34.3 room unit
Minor parameterization
Major parameterization.
Parameters
