Siemens DFR067A52, User Manual And Installation Instructions

Installation instructions

 en

15

4.

Snap the wall closing strip into the holders.

5.

Fit the grease filters.

6.

Establish the pipe connection.

7.

Establish the electrical connection.

Note:

You can conceal the housing of the extractor hood
within the upper cabinet. In doing so, observe the
following:

¡

The intermediate floor must not rest on the housing.

¡

The front panel must not be secured to the housing.

¡

Access to the housing must remain possible in or-
der to change the filter and for after-sales service.

Changing the filter pull-out's limit stop

On some versions of the appliance, the limit stop for
the filter pull-out can be changed. Spacers are included
with these appliances in order to set the appliance's
handle strip so that it is flush with the fitted unit.

1.

Pull the filter pull-out towards the front.

2.

Shorten the spacers to the required dimension and
insert them into the slot specified.

Removing the appliance

1.

Cover the hob to prevent damage.

2.

Disconnect the electrical connection.

3.

Remove the pipe connection.

4.

Remove the grease filters.

5.

Remove the protective caps from the fastening
bolts.

6.

Support the appliance with one hand while carrying
out the following steps.

7.

Push in the fastening bolts using a flat-blade screw-
driver and rotate by 90° until the fastening bolts un-
clip.

8.

Push in and turn the fastening bolts gently with your
fingers until the fastening bolts springs out of the
housing. Lift the appliance slightly and pull on the
fastening bolts until the locking mechanism in the
cabinet is released.