Siemens Dishwahser, Instructions For Use Manual

en

17

Washing dishes

Reduce costs!

If only a small number of
dishes have been loaded into
the dishwasher, selecting a
programme that operates at
the next lowest temperature
will usually suffice.

Programme specifications

The programme specifications can be
found in the summary of instructions.
Programme specifications refer to normal
conditions. Greater deviations may occur
due to:

varying amounts of dishes
water supply temperature
water pipe pressure
ambient temperature
mains voltage tolerances
and the tolerances specific
to the appliance (e.g. temperature,
amount of water, etc.)

The water consumption values refer
to a set water hardness value of 2.

Switching the dishwasher ON

Turn on the tap.
Set main switch 

1

 to ON.

Indicators light up according to the last
programme that was selected.
This same programme will run again if
no other programme button 

8

 is

pressed
For appliances with top basket feature:
If only the top basket is loaded, press
the top-basket button 

3

.

Close door.
The programme starts automatically.

End of programme

The programme has come to an end when
the PROGRAMME END indicator 

4

 and

the indicator for the selected programme
are both lit up.
Apart from this, the end of the programme
is indicated by a buzzer. This function can
be changed as follows:–

Hold down the function button  C  and
switch on the main switch 

1

. 

.

 Function button  C  flashes.

Each depression of function button  C
changes the buzzer in 4 stages (from
off to loud).
Switch off the main switch 

1

. 

.

 The setting is stored.

Switching the dishwasher OFF

Several minutes after the programme has
ended:

Open the door when the programme
has ended.
Set main switch 

1

 to OFF.

Turn the water tap off.
(Does not apply when Aqua-Stop unit
has been fitted)
Remove dishes, etc. when they have
cooled down.

Programme interruption

Carefully open the door, it could happen
that water splashes out of the
appliance. Only open completely when
the spray arm no longer turns.
If the programme is already in “drying”
mode, an acoustic signal reminds you
to close the appliance door or to abort
the programme.
Switch OFF the main switch 

1

.