en
18
Display window
Apart from information on the programme
sequence, the display window
)2
also
indicates additional information on
e.g. spray pressure.
If you would no longer like to have this
additional information displayed, proceed
as follows.
–
Open the door.
–
Switch on ON/OFF switch
(
.
–
Hold down programme button
#
and
press START button
)"
until the
digital display
8
•
:
‹
... is indicated.
–
Release both buttons.
The LED for button
#
flashes and the
digital display
8
displays the factory
setting
•
:
‹…
.
–
Press programme button
#
until the
factory set value
’
:
‹‚
is indicated on
the digital display
8
.
To change the setting,
–
By pressing the
3
button, you can
switch the on board computer
(additional programme information) off
’
:
‹‹
or on
’
:
‹‚
.
–
Press START button
)"
.
The set value is saved.
–
Close the door.
Timer programming
You can delay the start of the programme
in 1 hour steps up to 24 hours.
–
Open the door.
–
Switch on ON/OFF switch
(
.
–
Press the button
`
+ until
‹‚
is
flaching in the timer programming
display
X
.
–
Press + or – button until the
`
displayed time corresponds with your
requirements.
–
Press START button
)"
, timer
programming is activated.
–
To delete timer programming
`
,
press the + or – button until
‹‹
is
indicated on the digital display
X
.
You can change your programme
selection at any time until the
programme starts.
–
Close the door.
End of programme
The programme has ended when the
value
‹
:
‹‹
is indicated on the numerical
display
8
.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
–
Open the door.
–
Switch on ON/OFF switch
(
.
–
Hold down programme button
#
and
press START button
)"
until
•
:
‹
.... is
indicated on the digital display.
–
Release both buttons.
The LED for button
#
flashes and the
digital display
8
displays the factory
setting
•
:
‹…
.
–
Press programme button
#
until the
factory set value
›
:
‹ƒ
is indicated on
the digital display
8
.
To change the setting,
–
Press programme button
3
. Each
time the button is pressed, the set
value increases by one level; when the
value of
›
:
‹„
has been reached, the
display jumps back to
›
:
‹‹
(off).
–
Press START button
)"
, the set value
is saved.
–
Close the door.
