en
27
Warm water connection *
* depending on model
The dishwasher can be connected to cold
or hot water up to max. 60 °C.
Connection to hot water is recommended
if the hot water can be supplied
by energetically favourable means
and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting
‘
:
‹‚
allows you
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the incoming
water) of at least 40 °C and no more than
60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
–
Open the door.
–
Switch on ON/OFF switch
(
.
–
Hold down programme button
#
and
press START button
)"
until
•
:
‹
... is
indicated on the digital display.
–
Release both buttons.
The LED for button
#
flashes and the
digital display
8
displays the factory
setting
•
:
‹…
.
–
Press programme button
#
until the
factory set value
‘
:
‹‹
is indicated on
the digital display
8
.
To change the setting:
–
By pressing the
3
button, you can
switch the hot water setting off
‘
:
‹‹
or
on
‘
:
‹‚
.
–
Press START button
)"
.
The set value is saved.
–
Close the door.
Electrical connection
–
Connect the appliance to an alternating
current only, ranging from 220 V to
240 V and 50 Hz or 60 Hz via
a correctly installed socket with
protective earth conductor. See rating
plate for required fusing
9B
.
–
The socket must be near the appliance
and freely accessible following
installation.
–
The connection may be modified by
technicians only.
–
A power cord extension may be
purchased from customer service only.
–
Use only a residual current operated
circuit-breaker which features the
symbol
‚
. Only this extension
guarantees compliance with the
currently valid regulations.
–
The appliance features a water
damage protection system. Please
note the system will not function
unless
the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps
here.
–
Disconnect the appliance from the
power supply.
–
Turn off the water supply.
–
Disconnect the waste water and fresh
water connections.
–
Loosen the fastening screws under the
worktop.
–
If fitted, remove the base panel.
–
Pull out the appliance, carefully pulling
the hose behind.
