en
Operating the appliance
8
Setting the grill
The dial allows you to adjust the grill's heat setting. The
dial has no increments – the heat setting is infinitely
variable. The indicator light will light up when the grill
has been switched on.
Turn the dial to 0 to switch off the appliance.
Note:
The grill regulates the temperature by switching
the grill element on and off.The grill element may also
switch on and off at the highest setting.
Preheating the grill
Do not place the food to be grilled under the grill until
the preheating time has elapsed. Use the information
provided in the grill table to guide you. Always preheat
the grill at setting 9.
Preheating takes between 8 and 12 minutes.
Note:
Preheat the grill without food under it for no
longer than 8-12 minutes.Leaving the grill to heat up for
prolonged periods of time may cause the appliance to
shut down (overheating protection). Switch off the
appliance and allow it to cool down before switching it
back on again.
Overheating protection
The overheating protection switches the grill heating off
when the grill overheats. When the grill has cooled
down sufficiently, grill heating switches on again
automatically.
Adding water
:
Warning – Risk of scalding!
If water touches the hot wire grilling rack or grill element
during topping up, hot steam will be generated. Do not
reach over the grill while topping up and do not pour
water over the hot components.
If there is not enough water in the grill pan, the
overheating protection shuts down the appliance. It is
therefore important that you keep an eye on the amount
of water in the grill pan, and that you add more water if
required.
Note:
To add more water, there is no need to remove
the wire rack or to fold up the grill element. Before
adding more water, allow the grill to cool down
sufficiently.
Grilling with or without lava stones: 0.7 litres
After grilling
Only close the glass ceramic cover after the grill has
cooled down completely. Leave damp lava stones to
dry completely before you close the glass ceramic
cover or else mould could develop.
If the water is still hot when being drained, first add cold
water to cool it down! To drain the water, place a heat-
resistant container underneath the drain tap. Open the
tap by turning the lever 90° downwards. Then close the
tap by turning the lever upwards to the stop.
