en
Cleaning and servicing
12
Dis-
play
Selection
Time for selecting hotplates
– Unlimited: The last hotplate selected can
always be adjusted without having to select it
again.
1
– You can adjust the last hotplate selected
within 10 seconds after selecting it. After this
time you have to select the hotplate again be-
fore adjusting it.
Resetting to the factory settings
– Switched off.
1
– Switched on.
1
Factory setting
12.2 Changing basic settings
Requirement:
The hob is switched off.
1.
Switch on the hob.
2.
Within the next 10 seconds press and hold for
approx. 4 seconds.
a
and flash alternately on the left-hand display.
a
lights up on the right-hand display.
3.
Repeatedly touch until the required indicator ap-
pears on the left-hand display.
4.
Set the required value on the control panel.
5.
Press and hold for 4 seconds.
a
The setting is activated.
Tip:
To exit the basic settings without saving, switch off
the hob using . Switch the hob on again and reset.
13 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
13.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶
Never use unsuitable cleaning products.
Unsuitable cleaning products
¡
Undiluted detergent
¡
Detergent intended for dishwashers
¡
Abrasive cleaners
¡
Aggressive cleaning products such as oven spray
or stain remover
¡
Abrasive sponges
¡
High-pressure or steam jet cleaners
13.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note:
Note the information on unsuitable cleaning
Requirement:
The hob has cooled down.
1.
Remove heavy soiling using a glass scraper.
2.
Clean the hob with a cleaning product for glass
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip:
You can achieve good cleaning results using a
special sponge for glass ceramic.
13.3 Cleaning the hob surround
Clean the hob frame after use if dirty or stained.
Notes
¡
Note the information on unsuitable cleaning
products. →
¡
Do not use the glass scraper.
Summary of Contents for ET6 FMP1E Series
Page 2: ...2 Ø cm ET6 FMP1E ET6 FMP1R ...
Page 15: ......
