12
Rectifying faults
Malfunctions often have simple explanations. Please read the
following notes before calling the after
sales service.
After-sales service
Our after-sales service is there for you if your appliance should
need to be repaired. We are committed fo find the best solution
also in order to avoid an unnecessary call-out.
E number and FD number:
Please quote the E number (product number) and the FD
number (production number) of your appliance when
contacting the after-sales service. The rating plate bearing
these numbers can be found on the appliance certificate.
Please note that a visit from an after-sales service engineer is
not free of charge, even during the warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.
Indicator
Fault
Measure
Blank
There is no power supply.
Check the household fuse for the appliance. Check whether there is a power
cut by trying other electronic appliances.
“
is
flashing
The metal bar has been bent or struck. Wait a little and then reset.
Ҥ
+
number
Electronic fault.
Switch the appliance off and back on again after about 30 seconds using
either the household fuse or the circuit breaker in the fuse box. Contact the
after-sales service if this appears in the display again.
”ƒ
The electronics have overheated and
have switched off the corresponding
hotplate.
Wait until the electronics have cooled down sufficiently. Then touch a control
for the hotplate.*
”…
The electronics have overheated and
have switched off all hotplates.
Wait until the electronics have cooled down sufficiently. Then touch any
control.*
”ˆ
Frying sensor faulty.
Acknowledge the fault message by touching a control. You can cook without
the sensor frying system. Call the after
sales service.
”‰
The hotplate was in operation for too
long and has switched itself off.
You can switch the hotplate back on again immediately.
”Š
Electronic fault.
Switch the appliance off and back on again after about 30 seconds using
either the household fuse or the circuit breaker in the fuse box. Contact the
after-sales service if this appears in the display again.
* Do not place hot pans close to or on the control panel
GB
0844 8928999
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to 6 pence
may apply.
IE
01450 2655
