Electrical
connection
Connected load and required fuse or line
protecting cut-out are indicated on the rating
plate.
It must be ensured that the plug and socket
match, that the conductor cross-section is
sufficient and that the earthing system has
been installed in compliance with regulations.
Multiple plug connectors and extension cables
must not be used.
Do not connect the machine to electrical outlets
while your hands are wet or damp.
To remove the plug from the socket, grasp the
plug firmly and pull it out. Do not pull at the cable.
If the supply cord is damaged, it will be replaced
by a special cord or a assembly available from
the manufacturer or its service agent.
In the event that an earth-leakage circuit breaker
is to be used, only use types marked with the
following symbol: . Only this symbol can
guarantee compliance with all current regulations.
The voltage indicated on the rating plate at the
back of the machine must match the mains vo-
ltage at the installation location.
The machine must only be connect to an alter-
nating current supply via a correctly installed
earthed socket.
When heating, the maximum current of the
washing machine is 10A,so please make sure
that the power supply system(voltage; current
and the cable) is applicable to the load of the
applied appliance.
40
