Alarm
en
15
Sabbath mode
All non-essential functions are switched off so you can
also use the appliance on the Sabbath.
■
You can select a time between 1 and 96 hours
■
After the selected time expires, the appliance will
switch to normal operation.
■
To end Sabbath mode before expiry of the set time,
tap
×
.
The appliance switches off the following:
■
Ice maker
■
Audible signals
■
Interior lighting
■
Messages on the display
■
Background illumination of the display is reduced
Switching ice cube production on or off
Caution!
Damage to the appliance!
Never store bottles or food in the ice cube container,
even for short periods. This can block and damage the
ice maker.
Ice cube production starts as soon as the appliance
has reached the set temperature.
Note:
Ice cube production stops automatically when the
ice cube container is full.
M
Alarm
Alarm
Door alarm
If the appliance door is open for a long time, the door
alarm switches on. A message appears on the control
panel.
Turning off the door alarm
■
Close the door.
Note:
To mute the door alarm, you only have to
acknowledge the message on the control panel. If the
door remains opens a few more minutes, the message
will appear again.
Temperature alarm
If the freezer compartment becomes too warm, the
temperature alarm is switched on. A message appears
on the control panel.The message shows the warmest
temperature reached in the freezer compartment.
Caution!
Bacteria may develop during the defrosting process
and spoil the frozen food
Do not refreeze food after it has been defrosted or
started to defrost.
Refreeze food only after cooking. Do not store frozen
food for the maximum storage period.
Note:
The alarm may be actuated without risk to the
food in the following cases:
■
The appliance is put into service and does not yet
contain any food.
■
Large quantities of fresh food are placed in the
appliance.
■
The freezer compartment door has been open too
long.
Switching off the temperature alarm
1.
Check that the cause of the temperature alarm has
been eliminated.
2.
Press
Ok
button to acknowledge the message.
The message disappears. The control panel again
indicates the set temperature.
From this time on, the warmest temperature is
measured again and saved.
