20
FLUDEX 4612 en
Operating instructions 10/2017
6.1
Instructions for machining the finished bore, for axial fastening, set screws and balancing
6.1.1
Finished bore
•
On part 1:
Demount the flexible elements (12).
•
On part 11
FNDSHB
:
Remove parts 8 and 10.
•
On part 11; 32:
Remove part 10.
•
In case of hubcarrier part (120): Demount hubcarrier part (120) from the coupling,
remove Orings (117, 138) and retain them for reuse later.
•
Remove preservative agent from coupling parts.
CAUTION
Risk of corrosion burns through chemical substances
Avoid burns when working with corrosive cleaning agents.
Observe manufacturer’s instructions for handling cleaning agents and solvents.
Wear suitable personal protective equipment (gloves, safety glasses).
When machining the finished bore the parts must be carefully aligned. For the permissible radial and axial
runout errors and the permissible cylindricity tolerances, see standard "DIN ISO 286". The parts must be
fitted on the marked faces (
).
When machining the finished bore in the hubcarrier part (120), the axial runout face of the outer flange
must be finishturned during the same clamping operation (cut rate 0.2 ± 0.1 mm).
NOTICE
Damage to the coupling, damage to other components
Risk of damage to the coupling through incorrect rework (e.g. bore diameter too large).
The maximum permissible bore diameters (see table 1) are designed for drivetype fastenings without
taper action to standard "DIN 6885/1" and must not under any circumstances be exceeded. These
finishmachined bores must be 100 % checked with suitable measuring equipment.
Summary of Contents for FLENDER FLUDEX FNA
Page 2: ......
