Mounting and installation FC2080
Installing the key safe adapter [DE]
6
314 | 354
Building Technologies
008851_s_en_--
Fire Safety
2016-01-27
Example of installation
1. Prepare the carrier (19", option) (1) for the installation of the key safe
adapter (6) by mounting or removing the DIN rails as appropriate.
2. Install the key safe adapter (6) on one of the three positions provided on the
carrier (19", option) (1). The breakout openings on the rear panel of the key
safe adapter come to be positioned over the rectangular cable entry (5) on the
carrier (19", option).
3. If you use an I/O module FDCIO224 (3), install it on the DIN rail together with
an additional terminal block (2) for the cable connections of the components to
each other and to the FC2080.
If you use an I/O card, this point does not apply.
4. Wire the components according to their individual wiring diagram or as per the
following wiring examples.
6.14.2 Installation on the side wall
If key safe adapter SDA3000 cannot be installed on a carrier (19", option) due to
space issues, it should be installed on the right-hand side wall instead. The DIN rail
required for this is not included in the scope of supply for the standard cabinet.
Figure 175: Installation example of the key safe adapter
1 Right-hand side wall of the FC2080
2 I/O module FDCIO224 (example)
3 Additional DIN rail
4 Locking clamps for terminal block
5 Additional terminal block
6 Key safe adapter
1
2
3
4
5
6
