Mounting and installation of the compact control panels
Mounting and assembling a station
5
73 | 354
Building Technologies
008851_s_en_--
Fire Safety
2016-01-27
5.2.5 Mounting the cover cap
Prerequisites
● All options have been installed.
● The operating unit and the operating add-on have been mounted and fastened.
● The batteries have been installed.
● The mains voltage is switched off and secured against being switched on
inadvertently.
● The jumper wire of the batteries for serial connection should not be inserted.
The cover cap is hooked into the rear panel with four holder cams and screwed at
the top.
The housings must be opened and closed with an Allen key (standard equipment
for service technicians).
Mounting steps
1. Always hook the lower cover cap in first.
2. Insert the cover cap at an angle into the guides on the rear panel.
3. Secure the topmost cover cap with the hexagon socket screw. The bottom
cover cap is automatically fixed by the top one.
After the station has been assembled, it is ready to be commissioned.
Commissioning must only be carried out by a trained specialist.
