Add-on modules
U41126-J-Z156-1-74
English - 15
Installing network board with WOL
Install the network board as described in the operating manual for your unit.
Push the WOL cable onto the WOL plug connector of the system board.
i
To use the WOL functionality of a network board the power supply must provide a 5 V
auxiliary voltage of at least 1 A. If the system board was not already incorporated in a
device when you bought it you must check whether your power supply can provide the
auxiliary voltage.
You may find further information in the supplied description of the network board.
Replacing the lithium battery
!
Incorrect replacement of the lithium battery may lead to a risk of explosion.
The lithium battery must be replaced with an identical battery or a battery type
recommended by the manufacturer (CR2032).
Do not throw lithium batteries into the trashcan. It must be disposed of in accordance with
local regulations concerning special waste.
Make sure that you insert the battery the right way round. The plus pole must be on the
top!
1
2
3
+
+
+
+
Lift the contact (1) a few millimeters and remove the battery from its socket (2).
Insert a new lithium battery of the same type in the socket (3).
