7
Preparing to use the phone
Gigaset C340 / Im-eng / A31008-M1621-R101-1-7619 / starting.fm / 23.11.04
¤
Leave the handset in the charging cra-
dle in the base to charge up the
batteries.
If you have any questions or problems see
First battery charge and discharge
Battery charging is indicated in the top
right of the display by a flashing battery
icon
e
,
V
or
U
. During handset oper-
ation, the battery icon indicates the
charge status of the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged
and
discharged through use.
¤
To do this, leave the handset in the
base
without interruption
until the
battery icon stops flashing in the dis-
play (approx. 6h). Your handset need
not be switched on for it to charge.
¤
Once the batteries are fully charged,
remove the handset from the base and
do not put it back again until the batter-
ies are fully discharged.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and insert
them in again.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Your telephone is now ready for use
¤
Set the date and time (page 7) to
ensure that incoming calls are logged
with the correct time.
Activating/deactivating
the handset
a
Press the end call key and
hold. You hear the confirma-
tion beep.
Activating/deactivating
the keypad lock
#
Press the hash key
long
.
You hear the confirmation beep. The icon
Ø
appears in the display when the keypad
lock is activated.
The keypad lock deactivates automatically
when you receive a call and activates
again after the call.
Setting the date and time
§Menu§
¢
Settings
¢
Date/Time
~
Enter the day, month and year
with 6 digits and press
§OK§
.
Use
q
to move between the
fields.
~
Enter hours and minutes with
4 digits (e.g.
Q M 1 5
for
07:15) and press
§OK§
. Use
q
to move between the fields.
Notes:
– The handset may only be placed in the base
provided for it.
– When the handset is in the base, it charges
even if it is switched off. You will see the
charge status in the display.
– If the handset has switched itself off
because the batteries are flat and if it is
then placed in the base, it will switch itself
on automatically.
Note:
After the first battery charge
and
discharge
you may replace your handset in its base after
every call.
Note:
The handset displays an advisory message if
you press a key by accident while the keypad
lock is on. To deactivate the keypad lock, press
the hash key
#
long
.