9
Setting up the handset for use
First steps
CE 450 IP R / IM-Ost english / A31008-M1817-R601_1-7619 / starting.fm / 02.03.2007
Ve
rs
ion 2,
21
.12.
2006
¤
Insert the batteries the right way round (see figure).
The polarity is indicated in the battery compartment.
The handset switches on automatically. You will hear a confirmation tone.
Closing the battery cover
¤
Place the cover on the battery compartment as shown in the diagram, then push it up
until it clicks into position.
Opening the battery cover
¤
Press down on the battery cover below its upper end and slide the cover down.
Connecting the charging cradle
Connecting the charging cradle and mounting it on the wall (if required) is described at the
end of this user guide.
¤
To charge the batteries, leave the handset in the charging cradle.
For questions and problems see page 112.
Initial charging and discharging of batteries
Battery charging is indicated in the top right of the display by a flashing battery icon
e
,
V
or
U
. During handset operation, the battery icon indicates the charge status of the
batteries (page 1).
The correct charge status can only be displayed when the batteries are first fully charged
and
discharged through use.
¤
To do this, leave the handset in the charging cradle without interruption until the bat-
tery icon stops flashing in the display (around 13 hours).
Please note:
– Only place the handset in the charging cradle that is intended for it.
– If the handset has switched itself off because the batteries are flat and if it is then placed in the
charging cradle, it will switch itself on automatically.
