6
Setting up the telephone for use
Gigaset S430 / HGK-Taiwan-engl / A31008-M1625-Z201-1-7619 / starting.fm / 18.01.2005
Connecting the base station
¤
First
connect the mains unit and
then
the phone jack as shown below and
place the cable in the cable channels.
1 Underside of base station (enlarged view)
2 Mains adapter 230 V
3 Phone jack with phone cord
Please note:
u
The mains adapter must be
always
connected
, as the phone will not oper-
ate without mains connection.
u
If you buy another phone cable, ensure
that it has the correct phone jack
assignment:
Setting up the handset for use
Inserting batteries
¤
Fit the batteries with the
correct
polar-
ity (see diagram).
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
Position the cover pointing slightly
downwards and push it up until it clicks
into position.
Opening the battery cover
¤
Press below the upper curve on the bat-
tery cover and slide down.
Correct phone jack assignment
1 unused
2 unused
3 a
4 b
5 unused
6 unused
1
3
2
1
1
1
3
2
1
4
5
6
Caution:
Use only the rechargeable batteries recom-
mended by Siemens on page 44! Never use
conventional batteries (non-rechargeable) or
other battery types as this may cause signifi-
cant damage to health and property. For
example, the outer casing of the batteries
could be destroyed or the batteries could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
