58
Appendix
Gigaset S440-445 / IM-engl / A31008-M1635-A661-1-7619 / appendix.fm / 07.06.2005
Appendix
Care
¤
Wipe the base station and handset with
a
damp
cloth (do not use solvent) or an
antistatic cloth.
Never
use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch the handset off and remove
the batteries immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place
for at least 72 hours
(
not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your phone, you can contact us 24/7 at
www.siemens.com/gigasetcustomercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and
hold
the end call key
a
.
2. The batteries are flat.
¥
Charge or replace the batteries (page 8).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and
hold
the hash key
#
!
"Base station x"
flashes
in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 40).
3. The base station is not switched on.
¥
Check the base station mains adapter
Base Search flashes in the display.
The handset is set for
Best Base
and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
Handset does not ring.
1. The ringtone is switched off.
¥
Activate the ringtone (page 50).
2. Call diversion set to
All Calls
.
¥
Switch off Call Diversion (page 15).
You cannot hear a ringtone/dialling tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it
has the correct pin connections (page 7).
The other party cannot hear you.
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 14).
The incoming call number is not displayed
although CLIP is set
.
Phone number identification is not enabled.
¥
Caller
should ask network provider to acti-
vate phone number identification (CLI).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.
You cannot listen to messages on the T-Net
box
.
Your phone system is set for pulse dialling.
¥
Set your phone system to tone dialling.