12
First steps
Gigaset S800-S800A / en Großbritannien / A31008-M2125-L101-1-7619 / starting.fm / 20.05.2010
V
e
rsion 4.1, 21
.11.2007
Setting up the base and charger (if included)
The base and charger are designed for use in dry rooms in a temperature range of
+5°C to +45°C.
¤
Set up the base at a central point in the building on a level, non-slip surface or
mount the base (Gigaset S800 only) or charger on the wall (
The phone's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight or
other electrical devices.
u
Protect your Gigaset from moisture, dust, corrosive liquids and fumes.
Connecting the base
¤
First
connect the
power adapter
1
.
¤
Then
connect the
telephone jack
2
and insert the cables
into the cable ducts.
Please note:
u
The power adapter
must
always be connected
, as the phone will not operate without a mains con-
nection.
u
Use only the power adapter and phone cord
. Pin connections on tele-
phone cables can vary (pin connections
Please note
Pay attention to the range of the base.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside build-
ings. The range is reduced when Eco Mode (
page 57) is activated.
1
1
1
2
