79
Gigaset S800-S800A / en Großbritannien / A31008-M2125-L101-1-7619 / appendix.fm / 20.05.2010
V
e
rsion 4.1, 21
.11.2007
Questions and answers
If you have any questions about the use of
your phone, you can contact us 24/7 at
www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
Gigaset S800A only:
Anmelde- oder Verbindungsprobleme mit
einem Bluetooth Headset.
¥
Reset am Bluetooth Headset durchführen
(siehe Bedienungsanleitung Ihres Headsets).
¥
Anmeldedaten im Mobilteil löschen, indem
Sie das Gerät abmelden (
Anmeldeprozedur wiederholen
(
The display is blank.
1. The handset is not switched on.
¥
Press and
hold
the end call key
a
.
2. The battery is empty.
Charge the battery or replace it
(
Not all menu items are displayed.
The menu display is restricted (
standard mode
).
¥
Activate extended menu display
(
expert mode
•
No Base
flashes on the display.
1. The handset is outside the range of the base.
¥
Move the handset closer to the base.
2. The base's range is reduced because
Eco Mode is activated.
¥
Deactivate Eco Mode (
reduce the distance between the handset
and the base.
3. The base is not switched on.
Check the base power adapter
(
Please register handset
flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥
Register the handset (
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
2. Call divert set for "
All Calls
¥
Deactivate call divert (
3. The phone only rings if the phone number
has been transferred.
Switch on the ringtone for unknown calls
(
You cannot hear a ringtone/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥
Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer
(
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (
Forgotten the system PIN.
¥
Reset the system PIN to 0000 (
The other party cannot hear you.
You have pressed the mute button
h
. The
handset is "muted".
¥
Reactivate the microphone (
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller
should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input
(a
descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for pulse dialling.
¥
Set your PABX to tone dialling.
No time is specified for a message in the call list.
Date and time have not been set.
¥
Set the date and time (