64
Using a handset as a room monitor
Gigaset S800-S800A / en Großbritannien / A31008-M2125-L101-1-7619 / registr_sett.fm / 20.05.2010
V
e
rsion 4.1, 21
.11.2007
Changing a handset's
internal number
A handset is
automatically
assigned the
lowest free number when it is registered. If
all slots are occupied, number 6 is overwrit-
ten if this handset is in idle status. You can
change the internal number of all registered
handsets (1–6).
u
Open the list of handsets. Your
own handset is indicated by
f
.
§Options§
Open menu.
Assign Handset No.
Select and press
§OK§
.
r
Select number. Only numbers
that have not been assigned are
displayed.
§Save§
Press the display key to save the
input.
Using a handset as a
room monitor
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number. All of the
handset keys are deactivated, with the
exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) is terminated
after approximately 3 minutes (depending
on the base). When the room monitor is acti-
vated, all keys are locked except the end call
key. The handset's speaker is muted.
When the room monitor is activated, incom-
ing calls to the handset are indicated
with-
out a ringtone
and are only shown on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
If you accept an incoming call, the room
monitor is suspended for the duration of the
call, but the function
remains
activated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
Activating the room monitor and
entering the destination number
v
¢
É
¢
Room Monitor
¤
You can enter data in the following fields:
Activation:
Select
On
to activate.
Alarm to:
Select
Internal
or
External
.
External number:
Select the number
from the directory (press display key
ö
)
or enter it manually.
Internal number:
Select display key
§Change§
¢
. Select handset or
Call All
to
call all registered handsets
¢
§OK§
.
In idle status, the destination number or
the internal destination number is dis-
played.
Warning!
u
Always check the operation of the
room monitor before use. For exam-
ple, test its sensitivity. Check the
connection if you are diverting the
room monitor to an external
number.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the base/charger. This
ensures that the battery does not run
down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
