76
Connecting the base to the PABX
Gigaset S800-S800A / en Großbritannien / A31008-M2125-L101-1-7619 / pabx.fm / 20.05.2010
V
e
rsion 4.1, 21
.11.2007
Connecting the base to
the PABX
The following settings are only necessary if
your PABX requires them; see the PABX user
guide.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.
Dialling modes and recall
The current setting is indicated by
Ø
.
Changing the dialling mode
The following dialling modes can be
selected:
u
Tone dialling (DTMF)
u
Pulse dialling (PD)
v
¢
Ï
¢
Telephony
¢
Dialling Mode
s
Select dialling mode and press
§Select§
(
Ø
= selected).
Setting recall
Your phone is preset at the factory for oper-
ation on the main connection. For operation
on a PABX, you may have to change this
value. Please refer to the user guide for your
PABX.
v
¢
Ï
¢
Telephony
¢
Recall
s
Select recall and press
§Select§
(
Ø
= set value).
Possible values are:
80 ms, 100 ms, 120 ms, 180 ms,
250 ms, 300 ms, 400 ms, 600 ms,
800 ms.
Saving an access code
(outside line code)
Prerequisite:
You may have to enter an
access code in front of the number for exter-
nal calls in your PABX, e.g., "0".
v
¢
Ï
¢
Telephony
¢
Access Code
~
Enter or change access code,
max. 3 digits.
§Save§
Press the display key.
If an access code has been saved:
u
The access code is prefixed automatically
when you dial a number from the follow-
ing lists: SMS centre numbers, call lists or
answering machine list.
u
The access code must be entered when
dialling manually and when manually
entering directory, emergency/quick dial
numbers or SMS centre numbers.
u
If you copy the recipient's number from
the directory when sending an SMS, you
have to delete the access code.
u
An existing access code is deleted
using
Ñ
.
•
•
