49
Basic setup
Gigaset WLAN Repeater/ englisch / A31008-E505-B105-1-7619 / basic_config.fm / 08.03.2004
If your network does not have a DHCP server yet, then you can use the DHCP server inte-
grated in your Gigaset WLAN Repeater to assign the IP addresses of the connected
devices automatically.
ì
In this case, select the
On
option for the
DHCP server
.
ì
If you have activated the DHCP server integrated in your Gigaset WLAN Repeater,
you should also check the following settings and make any changes that are neces-
sary.
– The values
Start / end IP
define the range of IP addresses that your Gigaset WLAN
Repeater should use to automatically assign IP addresses to PCs.
– In
Default gateway
, enter the IP address of your Router that is to be used to con-
nect your PC to the Internet (e.g. 192.168.2.1).
Example of LAN settings with two Repeaters
If you want to use several Gigaset WLAN Repeater in the same network, make sure you
assign different IP addresses to each of them. Use an address block that is within the
selected subnet but not in the address block of the addresses automatically assigned by
the DHCP server in your network. In addition, you have to choose the address blocks for
the two DHCP servers as separate pools.
For two Repeaters in the same network, you could assign
u
for Gigaset WLAN Repeater A IP address 192.168.2.210, for its DHCP server address
block 192.168.2.211 to 192.168.2.239,
u
for Gigaset WLAN Repeater B IP address 192.168.2.240, for its DHCP server address
block 192.168.2.241 to 192.168.2.250.
Internet
)))
(((
)))
(((
(((
)))
(((
)))
Gigaset WLAN Repeater A
Gigaset WLAN Repeater B
