14
Basic settings
Your appliance has various Basic settings, which are preset at
the factory. You can, however, change these basic settings as
required.
If you want to cancel all the changes, you can restore the
factory settings.
1.
If required, turn the operating mode selector to
Û
to switch off
the appliance.
2.
Press and hold the
0
button until
™‹ ƒ
appears in the
display.
3.
Press the
0
button until the desired basic setting appears.
4.
Press the
A
or
@
button to change the basic setting.
5.
Press and hold the
0
button to exit basic settings.
The change is saved.
You can change the following basic settings:
Care and cleaning
In this section, you will find information on
■
the care and cleaning of your appliance
■
Descaling
:
Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of surface damage: Do not use
■
harsh or abrasive cleaning agents
■
oven cleaners
■
corrosive or aggressive cleaners, or those containing
chlorine
■
cleaning agents with a high alcohol content
If such an agent comes into contact with the front of the
appliance, wash it off immediately with water.
Caution!
Risk of surface damage: If descaler comes into contact with the
front of the appliance or any other sensitive surfaces, wash it off
immediately with water.
Remove food residues from the cooking compartment as soon
as the appliance has cooled.
Salts are very corrosive and can cause rust. Remove remains
of acidic sauces (ketchup, mustard) or salted food from the
cooking compartment immediately after cooling.
Do not use hard scouring pads or cleaning sponges.
Basic setting
Function
Possible settings
™‹ ƒ
Display brightness
™‹ ‚
= dark
™‹ ƒ
= medium
™‹ „
= bright
™‚ ƒ
Signal duration:
Sets the length of the audible signal at the end of an opera-
tion
™‚ ‚
= short (10 seconds)
™‚ ƒ
= medium (2 minutes)
™‚ „
= long (5 minutes)
™ƒ ‚
Displays the clock when the appliance is off
™ƒ ‹
= off
™ƒ ‚
= on
™„ ‚
Continues after the door is closed. Not necessary to restart
after the door has been opened
™„ ‹
= off
™„ ‚
= on
™… ƒ
Time until changes are automatically saved
™… ‚
= short (2 seconds)
™… ƒ
= medium (5 seconds)
™… „
= long (10 seconds)
™† ƒ
Sets the water hardness range for the descaling indicator
™† ‹
= softened
™† ‚
= soft (I)
™† ƒ
= medium (II)
™† „
= hard (III)
™† …
= very hard (IV)
™‡ ‹
Steam cooking heat signal
™‡ ‹
= off
™‡ ‚
= on
™ˆ ‹
Restore the appliance to the factory settings:
■
all changes to the basic settings are cleared
■
Automatic calibration is carried out again
™ˆ ‹
= do not restore
™ˆ ‚
= restore
