en
Trouble shooting
22
3
Trouble shooting
Trouble s
hooting
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Note:
If a dish does not turn out as well as you had
hoped, refer to the table section at the end of the
instruction manual, where you will find plenty of tips and
information.
:
Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
If an error message beginning with 'E' is shown, e.g.
E0111, switch the appliance off and then on again. If
this message appears again, contact the after-sales
service.
--------
Maximum operating time exceeded
Your appliance automatically ends the operation if no
duration has been set and the setting has not been
changed for a long time.
The point at which this occurs depends on the
temperature or grill setting that has been set.
A message appears on the display on the appliance to
say that the operation is being ended automatically. The
operation is then cancelled.
To use the appliance again, first switch it off. To switch
the appliance back on again set the required operation.
Replacing the bulb in the top of the cooking
compartment
If the cooking compartment light bulb fails, it must be
replaced. Heat-resistant, 35 watt, 230 V halogen bulbs
are available from the after-sales service or specialist
retailers.
When handling the halogen bulb, use a dry cloth. This
will increase the service life of the bulb. Only use these
bulbs.
:
Warning
Risk of electric shock!
When replacing the cooking compartment bulb, the
bulb socket contacts are live. Before replacing the bulb,
unplug the appliance from the mains or switch off the
circuit breaker in the fuse box.
:
Warning
Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
1.
Place a tea towel in the cold cooking compartment
to prevent damage.
2.
Turn the glass cover anti-clockwise to remove it
(figure
!
).
3.
Pull out the bulb – do not turn it (figure
"
).
Insert the new bulb, making sure that the pins are in
the correct position. Push the bulb in firmly.
4.
Screw the glass cover back in.
Fault
Possible cause
Information/remedial action
The appliance does not work
The fuse is faulty
Check in the fuse box to make sure that the fuse for
the appliance is in working order
Power cut
Check whether other kitchen appliances are working
The appliance door will not open; the
5
symbol is shown in the display
The appliance door is locked until the cooking com-
partment has cooled down.
Wait until the
5
symbol goes out
Although the appliance is switched
on, it cannot be operated; the
1
symbol is shown in the display
The child lock is activated
Press and hold the
1
button until the
1
symbol
goes out
The cooking compartment does not
heat and "Demo mode on" is shown in
the display
The appliance is in demo mode
Switch off the fuse in the fuse box and switch it back
on again after approx. 10 seconds. Switch on the
appliance and select "Demo mode off" in the settings
2
1
