Service information
lan2de.c01
A31003-K5020-S100-4-7620
Service Manual
1-3
For internal use only
Introduction
Card recognition is performed automatically in Hicom 150 E Office/Hicom 150 H
Point/Com/Pro. HiPath HG 1500 is installed as an individual board type in Hicom 150
E Office/Hicom 150 H Point/Com/Pro.
The following items can be administered in Hicom:
●
numbering scheme
●
associated dialing
●
answer group (PC telephone)
●
call forwarding (PC to fax)
●
suppression of incoming 0
●
CSTA interface
At initial startup, administration of HiPath HG 1500 can be performed via the V.24
interface or via the LAN connected to the HiPath HG 1500 board.
Details on the initial startup and on accessing the board can be found in the HiPath
HG 1500 Administration Manual.
A separate tool (Assistant) that can also be used by the customer or the LAN
administrator is provided for entering and modifying data, e.g. the IP address of the
customer LAN or ISDN numbers assigned to a communication partner. The data is
permanently stored in HiPath HG 1500. HiPath HG 1500 Assistant also facilitates the
storage of a corresponding configuration file. This can then be retrieved if a board
needs replacing. The tool also provides a facility for querying the software version.
Access to HiPath HG 1500 administration is password-protected. This password can
be changed; however, the Hicom password concept applies; see Table 1-1.
Note that only user and HICOM passwords are allowed.
A simple functional test can be performed directly at the customer PC or on a service
PC with a network card, vCAPI driver and a CAPI-based application.
APS transfer for the HiPath HG 1500 board is usually performed via the LAN using
the Assistant or, in exceptional circumstances, via the V.24 interface using the
Loader.
Cable with reference number S30122-X5468-X is used for the V.24 port of the HiPath
HG 1500 board (see also Section 2.1.3 ).
