en
Energy consumption display
22
Display
Function
Automatic switch-off of the cooking
zones
Switched off.
1
-
Time until automatic switch-off.
Duration of the timer end signal tone
10 seconds.
1
30 seconds.
1 minute.
The power limitation function limits the
total power of the hob
. The available settings depend on the
maximum power of the hob
.
Deactivated. The hob's total power out-
put is limited.
1
1000 W minimum power
. 1500 W
...
3000 W is recommended for 13 A.
. 3500 W is recommended for 16 A.
4000 W
. 4500 W is recommended for 20 A.
...
or . The hob's total power output is lim-
ited.
Time for selecting the cooking zone
Unlimited: The cooking zone that was
last set remains selected.
1
Limited: The cooking zone only remains
selected for a few seconds.
Cookware test, result
Not suitable.
Not optimal.
Suitable.
Automatic management with power limit-
ation
Deactivated: Shows the power limitation
according to the power management
function.
1
Activated: Does not show the power limit-
ation of the power management function.
Restoring factory settings
Individual settings.
1
Factory settings.
1
Factory setting
17.2 To go to the basic settings
Requirement:
The hob must be switched off.
1.
To switch on the hob, touch .
2.
Within the next 10 seconds, touch and hold for
four seconds.
Product information
Display
Directory for the technical after-sales
service (TK)
Production number
Production number 1
.
Production number 2
.
a
The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
3.
Touch to access the basic settings.
a
and , along with , light up alternately as a pre-
setting.
4.
Touch repeatedly until the required function is dis-
played.
5.
Select the required setting in the settings range.
6.
Touch and hold for four seconds.
a
The settings are saved.
17.3 Exiting the basic settings
▶
Touch to switch off the hob.
18 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→