15
Washing and drying options
Spin rpm button
The spin speed can be individually adjusted for each programme.
To set the spin speed, press the
Spin rpm
button repeatedly until the
required spin speed is displayed.
$
(Rinse stop)
deactivates the spin function.
The laundry remains in the rinsing water.
The automatic unbalanced load detection system ensures that the laundry
is evenly distributed using several initial spins. If the laundry is extremely
unevenly distributed, the speed of the final spin is reduced or the spin
cycle is not performed for safety reasons.
Option button
Select button
The set washing programmes can be individually adjusted.
To choose the required washing option:
press the
Option
button repeatedly until the required washing option
is selected (indicator lamp flashes).
Press the
Select
button to switch the washing option on or off
(indicator lamp is lit/not lit).
If you press and hold the
Option
button, the appliance scrolls through all
the washing options.
Washing options
!
-
(Prewash)
Prewash at 35 °C. Suitable for heavily soiled laundry.
@
-
(Intensive)
Prolonged washing time. Suitable for heavily soiled laundry with dried-on
stains. Cannot be combined with
R
Flexi Time
.
Q
-
(Easy-iron)
Special spin sequence with subsequent fluffing. Gentle final spin at
reduced speed. Slightly increased residual moisture in the laundry.
Reduces creasing and laundry is easier to iron.
)
-
(Water Plus)
Increased water level and additional rinse cycle. For regions with very soft
water or for further improving the rinsing result. Any detergent residues
are better removed.
R
- Flexi Time
Sets the washing time:
normal-medium-short
.
C
- Signal
Activates or deactivates the audible signal.
Delay Start button
You can postpone the start of the programme before it begins. Using the
remaining time, you can determine when the selected programme is to
end. The remaining time can be set in one-hour increments, up to a
maximum of 24 hours. Press the
Delay Start
button repeatedly until the
required number of hours is displayed.
Then press the
A
(Start/Pause) button. The programme will start after a
delay according to the set remaining time. The time required until the end
of the programme is shown on the display.
Rinse Hold
Unbalanced load
detection system
