en
Childproof lock
18
‒
For some programmes, the button can be
used to delay the end.
→
"Setting the end time", Page 13
a
After a few seconds, the programme starts and the
cooking time counts down.
a
If the programme has ended, an audible signal
sounds and the display shows the cooking time as
zero.
4.
When the programme ends:
‒
Press any button to end the audible signal pre-
maturely.
‒
To set a cooking time for further cooking, press
the button. The appliance continues to heat
using the programme settings.
‒
When your food is ready, switch off the appli-
ance.
12 Childproof lock
You can secure your appliance to prevent children
from accidentally switching it on or changing the set-
tings.
Note:
You can go to the basic settings →
to
specify whether you want the option to set the child-
proof lock.
12.1 Activating and deactivating the
childproof lock
Requirement:
The function selector must be set to the
"Off" position .
▶
To activate the childproof lock, press and hold the
button until appears in the display.
‒
To deactivate the childproof lock, press and hold
the button until goes out in the display.
13 Sabbath mode
You can set a time of over 70 hours using Sabbath
mode. You can use
Top/bottom heating
to keep food
warm between 85 °C and 140 °C during this time
without having to switch the appliance on or off.
13.1 Starting Sabbath mode
Notes
¡
If you open the appliance door during operation, the
appliance stops heating. When you close the appli-
ance door, the appliance continues to heat again.
¡
Once it has started, you can no longer change or in-
terrupt Sabbath mode.
¡
You cannot delay the end time for Sabbath mode.
Requirement:
Sabbath mode is activated in the basic
settings.
→
1.
Use the function selector to set the programmes .
a
appears in the display.
2.
Use the temperature selector to set the temperature.
3.
Press the button repeatedly until is highlighted
on the display.
4.
Use the or button to set the time.
a
After a few seconds, the appliance starts heating
and the cooking time counts down.
5.
Once the time has elapsed, the display shows the
time as zero. The appliance stops heating up and
responds again as usual outside of Sabbath mode.
‒
Switch off the appliance.
The appliance automatically switches off after ap-
prox. 10 to 20 minutes.
14 Basic settings
You can configure the appliance to meet your needs.
14.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display
Basic setting
Selection
Signal duration upon completion of a time or
timer period
= 10 seconds
= 30 seconds
1
= 2 minutes
Waiting time until a setting is applied
= 3 seconds
1
= 6 seconds
= 10 seconds
1
Factory setting (may vary according to model)
2
Depending on the appliance specifications
