Siemens iQ500 LI67SA560S, Instructions For Installation And Use Manual

en

    Operating the appliance

6

1

Operating the appliance

Operating the appliance

These instructions apply to several appliance variants. 

It is possible that individual features are described 

which do not apply to your appliance.

Note: 

Switch on the extractor hood when you start 

cooking and switch it off again several minutes after you 

have finished cooking. This is the most effective way of 

removing the kitchen fumes.

Control panel model 1

Control panel

Setting the fan

Switching on

Pull out the filter pull-out and press the 

#

 button. The 

fan starts at setting 

ƒ

.

Press the + or - button to change the fan strength.

Switching off

Press the 

#

 button. Slide the filter pull-out in.

Intensive setting

You can use the intensive setting if there is a large 

build-up of odours and fumes/vapours.
Press the + button when the fan is at setting 

„

.

The intensive setting

2

‚

 is activated. Pressing the + 

button again activates the intensive setting 

2 

ƒ

.

After approx. six minutes, the electronics automatically 

reduce the fan to a lower setting . If you want to end the 

intensive setting before the preset time expires, press 

the - button until the required fan setting is reached.

Fan run-on time

If you slide in the filter pull-out, the run-on time will be 

activated for as long as the extractor hood is operating.
After approx. 10 minutes, the fan switches off 

automatically.

Lighting

The lighting can be switched on and off independently 

of the fan.
Press the 

A

 button.

Setting the brightness

Press and hold the 

A

 button until the desired 

brightness is reached.

Saturation display

When the metal grease filters or the activated charcoal 

filter are/is saturated, an audible signal will sound for 

approximately 4 seconds after the fan is switched off.
In addition, the corresponding symbol will appear on 

the display: 

■

Metal grease filter:

!

■

Activated charcoal filter: 

"

If you have not yet done so, the metal grease filters 

should now be cleaned or the activated charcoal filter 

replaced. 
For instructions on how to clean the metal grease filters, 

please refer to the 

~

 "Cleaning and maintenance" 

on page 8

 section.

The saturation indicators can be reset while they are 

flashing. To do this, press the – button.

Switching over the display for circulating-air mode

For circulating-air mode, the electronic control display 

must be switched over accordingly:

■

The extractor hood must be connected and switched 

off.

■

Press the 

#

 and - buttons at the same time until the

™

"

 display for starter sets for circulating-air mode 

or

the 

’

"

 display for CleanAir circulating air modules

lights up.

■

Repeatedly press the button combination to switch 

the electronic control display back to exhaust air 

mode (

!

 display).

Audible signal 

Switching on the acoustic signal

When the fan is switched off, press the 

#

 and + at the 

same time for approx. three seconds. An 

acknowledgement signal sounds.

Switching off the acoustic signal

Repeat the "Switching on the acoustic signal" process.

Explanation

#

Fan on/off

 -

Reduce the fan settings/fan run-on time

 +

Increase the fan settings/intensive setting 1, 2

A

Light on/off/dimming