Installation instructions
en
17
9.
Disconnect the power supply from the motor.
10.
Remove the air pipe connector.
Preparing the ceiling
Requirements
¡
The ceiling must be heat-resistant up to 90 °C.
¡
The ceiling must still be sturdy after the cut-outs
have been made.
1.
Saw a cut-out into the ceiling.
2.
If required, compensate for the ceiling thickness by
13 mm by placing wood underneath.
3.
Remove any shavings.
Installing the appliance
1.
Disconnect the appliance from the power supply.
Unplug the appliance from the mains or switch off
the circuit breaker in the fuse box.
2.
Insert the motor block in the ceiling.
3.
Align the motor block, mark the drill holes, and set
the motor block down again.
4.
Screw in one of the two middle screws, but do not
screw it in completely.
5.
Plug the mains plug into the earthed socket.