en
37
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Possible cause
Remedial action
Temperature differs greatly
from the set value.
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Displays do not illuminate.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Connect mains plug. Check whether the power
is on, check the fuses.
The light does not function.
The LED light is defective.
See chapter “Light (LED)” section.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is closed and opened,
the light is on again.
Bottom of the refrigerator
compartment is wet.
The condensation channel
or drainage hole are blocked.
Clean the condensation channel
and the drainage hole. See chapter Cleaning
the appliance. Fig.
#
The temperature in the
refrigerator compartment is
too cold.
Freezer compartment door is
open.
Close the freezer compartment door.
Temperature has been set
too low.
Increase the temperature.
The Super function is
switched on.
Switch off Super function.
The refrigerating unit
is switching on more
frequently and for longer.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstacles.
Summary of Contents for KI V Series
Page 99: ... ELJ R 0RQWKV 0RQWKV 0RQWKV QR URVW ...
Page 100: ... ...
Page 101: ... FD Nr E Nr ...
Page 102: ...9000967984 9411 de en fr it nl ...