en
25
Aligning the doors
The appliance has adjustable door jambs. These can
be used to align the doors.
1. Open both refrigerator compartment doors and the
uppermost drawer of the freezer compartment.
2. There is a screw under the lower hinge of each
refrigerator compartment door.
Use a cross-tip screwdriver to align the doors by
adjusting the screws.
3. The corresponding door is raised by 1.5 mm with
each clockwise turn of the screw.
The maximum adjustable height is 3 mm.
Note
To make it easier to turn the screws, the doors should
not have any load in them. Lifting the door also
facilitates its adjustment.
Fit the door handle covers
Fit the enclosed covers to the edges of the door
handles. This will prevent children from injuring
themselves on the edges.
Connecting the appliance
Have a technician install and connect the appliance
according to the enclosed installation instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until
the appliance has been installed.
In addition to the statutory national regulations, observe
the connection conditions of the local power supply
companies.
After installing the appliance, wait at least 1 hour until
the appliance starts up. During transportation the oil
in the compressor may have flowed into
the refrigeration system.
Before switching on the appliance for the first time,
clean the interior of the appliance (see chapter
“Cleaning the appliance”).
Electrical connection
The socket must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with the protection class I.
Connect the appliance to 220-240 V/50 Hz alternating
current via a correctly installed socket with protective
conductor. The socket must be fused with a 10
to 16 A fuse.
For appliances operated in non-European countries,
check whether the stated voltage and current type on
the rating plate match the values of your mains supply.
These specifications can be found on the rating plate
(see chapter “Customer service”).
m
Warning
Never connect the appliance to electronic energy saver
plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters are used
for photovoltaic systems which are connected directly
to the national grid. Sine-controlled inverters must be
used for isolated applications (e.g. on ships or in
mountain lodges) which are not connected directly to
the national grid.
Removing the appliance door
If the appliance will not fit through the house door,
the appliance doors can be unscrewed.
m
Caution
Only customer service may unscrew the appliance
doors.
