en
22
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in
the compressor may have flowed into
the refrigeration system.
Before switching on the appliance for
the first time, clean the interior of
the appliance (see chapter “Cleaning
the appliance”).
Electrical connection
The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the
protection class I. Connect the appliance
to 220–240 V/50 Hz alternating current
via a correctly installed socket with
protective conductor. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply. This
information can be found on the rating
plate. Fig.
-
ã=
Warning
Never connect the appliance
to electronic energy saver plugs.
Our appliances can be used with mains
and sine-controlled inverters. Mains-
controlled inverters are used
for photovoltaic systems which
are connected directly to the national
grid. Sine-controlled inverters must be
used for isolated applications (e.g. on
ships or in mountain lodges) which are
not connected directly to the national
grid.
Getting to know your
appliance
Please fold out the illustrated last page.
These operating instructions refer
to several models.
The features of the models may vary.
The diagrams may differ.
Fig.
1
A
Refrigerator compartment
B
Cool-fresh compartment
(at almost 0°C)
1-5
Controls
6
Light
7
Glass shelf in the refrigerator
compartment
8
Vario shelf
9
Ventilation
10
Partition with humidity controller
11
Vegetable container
12
“Cool-fresh” container
13
Height-adjustable feet
14
Butter and cheese compartment
15
Shelf for tubes and small tins
16
Door shelf “EasyLift”
17
Door ventilation
18
Shelf for large bottles
Downloaded from www.vandenborre.be
