9
Halogen bulbs:
1.
Switch off the extractor hood and isolate
by pulling out the mains plug or swit-
ching off the disconnector on the instal-
lation side.
When switched on, the halogen
bulbs become very hot. Even for some
time after the bulbs have been switched
off there is still a risk of burns.
2.
Remove the bulb ring with a screwdriver
or similar tool.
3.
Replace the halogen light bulb
(conventional halogen bulb, 12 Volt,
max. 20 Watt, G4 cap).
Caution:
Refer to for plug-in
lampholder.
Take hold of the bulb with a clean cloth.
4.
Re-insert the bulb ring.
5.
Plug the appliance into the mains or
switch it on at the fuse box.
Note: I
f the light does not function, check
that the bulbs have been inserted correctly.
Cleaning and care
9000.022 567.qxd 06.09.2006 11:36 Uhr Seite 9
