Basic operation
en
7
6 Basic operation
6.1 Switching on the appliance
▶
Press .
a
The appliance starts at fan setting 2.
6.2 Switching off the appliance
▶
Press .
6.3 Selecting a fan setting
▶
Press or .
6.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
▶
Press repeatedly until
appears on the display.
a
After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
6.5 Switching off intensive mode
▶
Press until the required fan setting is reached.
6.6 Switching on the boost function
The boost function is a short-term maximum power set-
ting which can be activated in any fan setting.
▶
Press .
a
After approx. 20 seconds, the fan automatically
switches back to the fan setting that was previously
set.
6.7 Switching on the fan run-on, variant 1
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press until appears on the display.
a
The fan run-on starts at fan setting 1.
a
The appliance switches off automatically after ap-
prox. 10 minutes.
6.8 Switching on the fan run-on, variant 2
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press
a
The fan run-on starts at fan setting 1.
a
The appliance switches off automatically after ap-
prox. 10 minutes.
6.9 Switching off the fan run-on, variant 1
▶
Press .
6.10 Switching off the fan run-on, variant 2
▶
Press
6.11 Switching on automatic mode
1
The optimum fan setting is set automatically using a
sensor.
▶
Press
.
6.12 Switching off automatic mode
1
▶
Press
.
a
The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a
Automatic mode runs for a maximum of four hours.
6.13 Sensor control
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡
Factory setting: 5
¡
Lowest setting: 0
¡
Highest setting: 9
6.14 Setting the sensor control
Requirement:
The appliance is switched off.
1.
Press and hold
.
a
The setting is displayed after approx. one second.
2.
Press or to change the setting.
3.
Release
to save the setting.
6.15 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Note:
The saturation indicator does not apply for non-
regenerative odour filters that are inserted downstream
of the grease filters. These odour filters must be re-
placed twice a year.
Requirements
¡
After the appliance has been switched off, ap-
pears in the display for the grease filter.
¡
After the appliance has been switched off, ap-
pears in the display for the odour filter.
▶
Press and .
a
The saturation indicator is reset.
6.16 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:
The appliance is switched off.
1.
To set circulating-air mode (non-regenerative filter),
press and hold and until indicator 2 appears
on the display.
1
Depending on the appliance specifications
Summary of Contents for LC67BIR55
Page 19: ......
