Siemens LC67KHM60, Instructions For Installation And Use Manual

 Installation  

en

17

Wall-mounting the appliance and levelling it

1.

First remove the protective film from the back of the 

appliance and, following installation, remove the rest 

of the film.

2.

When mounting the appliance, ensure that it 

engages properly with the mounting supports.

3.

If required, the appliance can be moved to the right 

or to the left.

4.

Firmly tighten the screws for the mounting supports. 

Hold the bracket firmly when doing so. 

¨

5.

If no duct is to be fitted, screw in the two locking 

screws without the bracket. 

©

Connecting the pipes

If the extractor hood is to be operated in exhaust-air 

mode, the pipes must be connected. If the extractor 

hood is to be operated in air-recirculation mode, an 

optional accessory must be fitted. To do this, refer to 

the installation instructions provided.

Note: 

If an aluminium pipe is being used, smooth the 

connection area beforehand.

Exhaust air pipe, dia. 150 mm (recommended size)

Fit the exhaust air pipe directly to the air-pipe connector 

and seal the joint.

Exhaust air pipe, dia. 120 mm

1.

Fit the reducing connector directly to the air-pipe 

connector.

2.

Attach the exhaust air pipe to the reducing 

connector. 

3.

Use suitable means to seal both joints.

Attaching the flue duct

If the extractor hood is to be operated in exhaust-air 

mode, a flue duct must be fitted. 
The flue duct does not need to be fitted for air-

recirculation mode.

:

Warning

Risk of injury!

From sharp edges during installation. Always wear 

protective gloves while installing the appliance.

:

Warning

Risk of electric shock!

Components inside the appliance may have sharp 

edges. These may damage the connecting cable. Do 

not kink or pinch the connecting cable during 

installation.

1.

Separate the flue duct sections by removing the 

adhesive tape. 

2.

Remove the pieces of protective film from both flue 

duct sections.

3.

Push one flue duct section into the other.

Notes

– To prevent scratches, lay paper over the edges of 

the outer flue duct section to protect the surface.

– The slots of the inner flue duct section point 

downwards.

4.

Place flue ducts sections on the appliance.

5.

Slide the inner flue duct section upwards, attach it to 

the left and right sides of the retaining bracket, and 

then slide it down to engage it. 

¨

6.

Screw the flue duct section to the sides of the 

retaining bracket using two screws. 

©

7.

Clip the lower flue duct section in at the retaining 

bracket. The connection cable must not be 

damaged. 

ª

Note: 

If an air-recirculation optional accessory has been 

fitted and the extractor hood is to be operated without a 

flue duct, the cable must be wound onto the connector.