Siemens LC91KWP60, Instructions For Installation And Use Manual

  Cleaning and maintenance   

en

9

Saturation display

If the metal grease filters or activated charcoal filter are/

is saturated, the corresponding symbols will flash once 

the appliance has been switched off:

■

Metal grease filter:

!

■

Activated charcoal filter:

"

■

Metal grease filter and activated charcoal filter: 

!

and 

"

If you have not yet done so, the metal grease filters 

should now be cleaned or the activated charcoal filter 

replaced. 

~

 "Cleaning and maintenance" on page 9

The saturation indicators can be reset while they are 

flashing. To do this, touch the 

A

 symbol.

Switching over the display for air recirculation mode

For air recirculation mode, the electronic controller must 

be switched over accordingly:

■

The extractor hood must be connected and switched 

off.

■

Touch and hold the 

#

 and 

@

 symbols at the same 

time until "2" lights up for air recirculation mode 

(filters that cannot be regenerated).

■

Repeatedly touching and holding this button 

combination makes "3" light up for air recirculation 

mode (filters that can be regenerated).

■

Repeatedly pressing and holding this button 

combination switches the electronic controller back 

over to air extraction mode ("1" ).

emotionLight Pro

The emotionLight Pro can be switched on and off 

independently of the fan.
Touch the 

i

 symbol.

Setting the brightness

Press and hold the 

i

 symbol until the required 

brightness is reached.

Setting the colour

1.

Switch off the fan.

2.

Touch the 

i

 symbol. 

3.

Touch the 

A

 or 

@

 symbol until the colour you require 

is selected.

Audible signal 

Switching on

Touch and hold the 

#

 and 

&

 symbols at the same time 

for approximately 3 seconds when the fan is switched 

off. An audible signal will sound as an 

acknowledgement.
When the signal tone is activated, 

‚

 will be lit.

Switching off

Touch and hold the 

#

 and 

&

 symbols at the same time 

for approximately 3 seconds when the fan is switched 

off. An audible signal will sound as an acknowledgement.
When the signal tone is deactivated, 

‹

 will be lit.

2

Cleaning and maintenance

Cleaning and maintenance

:

Warning

Risk of burns!

The appliance becomes hot during operation. Allow the 

appliance to cool down before cleaning.

:

Warning

Risk of electric shock!

Penetrating moisture may result in an electric shock. 

Clean the appliance using a damp cloth only. Before 

cleaning, pull out the mains plug or switch off the circuit 

breaker in the fuse box.

:

Warning

Risk of electric shock!

Do not use any high-pressure cleaners or steam 

cleaners, which can result in an electric shock.

:

Warning

Risk of injury!

Components inside the appliance may have sharp 

edges. Wear protective gloves.

:

Warning

Risk of injury!

Risk of trapping body parts when opening and closing 

the glass front. Do not reach into the area behind the 

glass panel, and keep your fingers away from the 

hinges.

Cleaning agents

To ensure that the different surfaces are not damaged 

by using the wrong cleaning product, follow the 

instructions in the table. Do not use any of the following:

■

Harsh or abrasive cleaning agents, e.g. scouring 

powder or liquid scouring cleaner,

■

Cleaning products with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

Pressure washers or steam cleaners,

■

Cleaning products that dissolve limescale,

■

Aggressive all-purpose cleaning products,

■

Oven spray.

Note: 

Wash new sponge cloths thoroughly before use.

Note: 

Follow all instructions and warnings included with 

the cleaning products.